Flap Wheel 30 X 10 X 6mm Shaft 60 Grit Per Each

Features

• Abrasive flap wheel Designed for compatible sanding and finishing applications.
• 30mm diameter Suitable for smaller contact areas and controlled finishing work.
• 10mm wheel width Provides a practical abrasive face for detail and edge applications.
• 6mm shaft Fits compatible machines and chuck systems accepting this shaft size.
• 60 grit Practical abrasive grade for coarser sanding and surface preparation.

Benefits

• Controlled surface preparation: Helps sand, smooth and prepare compatible surfaces.
• Useful coarse grit: 60 grit is practical for faster material removal and preparation work.
• Compact working size: The 30 x 10mm size is useful for smaller areas, edges and shaped sections.
• Easy machine fitment: The 6mm shaft allows use with suitable machines and chuck setups.
• Workshop ready: Useful for fabrication, maintenance, repair and general surface preparation work.

Application

• Sanding and finishing compatible surfaces
• Surface preparation before coating or further finishing
• Blending edges and light marks where suitable
• Deburring and cleaning compatible materials
• Small area and detail sanding applications
• Workshop, maintenance and repair work
• Use with compatible machines accepting 6mm shaft flap wheels

Extra Information

• Confirm that the 30 x 10mm size and 6mm shaft are compatible with the machine before use.
• Use only on suitable materials and applications matched to the abrasive grit.
• Make sure the flap wheel shaft is correctly fitted and securely clamped before starting the machine.
• Do not use the flap wheel if it is damaged, loose, worn unevenly or incorrectly mounted.
• Use light, controlled pressure and allow the abrasive flaps to do the work.
• Do not exceed the machine or accessory manufacturer’s recommended operating limits.
• Store abrasive wheels dry and protected from damage when not in use.

Safety

• Wear suitable eye protection, hearing protection, gloves and a dust mask when sanding or finishing.
• Use only with compatible machines, chucks and collets.
• Disconnect the machine from power before fitting, adjusting or removing the flap wheel.
• Inspect the flap wheel before use and do not use it if damaged, loose or excessively worn.
• Make sure the shaft is securely clamped before starting the machine.
• Do not exceed the machine or accessory manufacturer’s recommended operating limits.
• Keep hands clear of the rotating wheel and work area.
• Secure the workpiece properly before sanding or finishing.
• Use suitable dust extraction or respiratory protection where required by the material and application.
• Allow the machine and wheel to stop completely before setting the tool down or touching the accessory.

Specifications